Microbe-Lift Filter Gel is a technological breakthrough because it's the first product that puts the bacteria right where
you want it and it STAYS THERE! Filter Gel will quickly attach to and populate any filter media including foam,
strapping, floss, bio-balls, ceramic media, etc. This will help to rapidly establish the necessary biological activity in
your filter to stabilize your pond's environment quickly. It will also help restore this activity to your filter when you
clean or change the media in your filter.
- Easily applies to the filter pads/media without running or getting messy
- Contains the same spectrum of bacteria found in MICROBE-LIFT/PL
- Contains naturally occurring biopolymers, helping organisms quickly attach to the media
allowing for an 80% reduction in filter start-up time
- Helps to stabilize pond environment quickly upon startup and to eliminate transient instability
that can occur when filter media is cleaned or replaced
- Allows for more frequent cleaning of filters without subsequent instability if a pond has a high
solids loading where frequent cleaning is beneficial
- Reduces the frequency of cleaning by accelerating the breakdown of organic solids that lead
to high maintenance requirements
- Helps to establish denitrification in the filter which can lower nitrate levels in the pond
Application: Inoculate (spread) Filter GEL directly to filter pad or media. The Filter GEL will
absorb into the pad/media by letting is set for 1 to 2 hours before inserting back into the filter or
skimmer. After insertion, turn off recirculation pump for 1 to 2 hours, providing water can maintain
adequate oxygenation without circulation for this amount of time. Repeat application each
cleaning/replacement of filter pads/media. For normal maintenance use Mircrobe-Lift Clean &
Clear.